FAQs

What is the best way to test for cracks in concrete that are horizontal to the test surface?

The Impact Echo (IE) test method can identify cracks 3.2” (81mm) to 6’ (18 m) deep. Olson’s Concrete Thickness Gauge (CTG) can be purchased to use with your tablet. IE systems are also available with our Freedom Data PC (FDPC), NDE 360 and NDE-DAQ platforms. Our Impact Echo Scanner (IES) is available with our FDPC, NDE 360 and NDE-DAQ platforms.

 

What is the best way to test the depth of vertical (surface) cracks in concrete?

Spectral Analysis of Surface Waves (SASW) can help identify the depth of surface cracks. Olson’s SASW systems are available with our FDPC, NDE 360, and NDE-DAQ platforms.

 

What is the best way to test for voids or honeycombing in concrete?

The Ultrasonic Pulse Velocity (UPV) test method is ideal for identifying voids and honeycombing, especially when there is access to both sides of the structure to be tested. Testing for voids/honeycomb is often performed in conjunction with the IE test method. Olson’s platforms allow you to use both of these test methods on the same platform (FDPC or NDE 360).

 

What is the best way to test the depth of an existing shaft foundation?

The Sonic Echo (SE) or Sonic Echo/Impulse Response (SE/IR) test method can determine foundation depth up to 30 x the shaft diameter. Olson’s Foundation Test Gauge (FTG) is an SE device that can be purchased to use with your tablet. SE and SE/IR systems are also available with our FDPC, NDE 360 and NDE-DAQ platforms.

 

Is it possible to test the length of a wooden pier?

Wooden piers can be tested if there is access to the upper portion of the pier. The default velocity in Olson’s software (which uses an average velocity value for typical sound concrete) must be changed to a value that is appropriate for wood.

CTG, FTG, RTG – No Signal on Software

  • How to check if your Windows 10 device is getting a signal:
    • Click the magnifying glass and type” SOUND ” in the search bar.

    • Under the "Input" section select the correct input.

    • Tap the accelerometer (on the FTG or RTG) with your finger.
    • The bar below "Test your microphone" will bounce if Windows is getting a signal. This indicates that the hardware is working correctly.
    • Restart your Windows device.

CTG Capabilities

  • The CTG will work on thicknesses up to ~18 in (46 cm) with the equipment's built-in solenoid.
  • An 8-ounce hammer is recommended for thicknesses up to ~36 in (91 cm), and a 1-pound hammer for thicknesses up to ~60 in (1.5 m).
  • The CTG will not work through a rubber membrane or carpet.

 

FTG Capabilities

  • A 1-pound hammer is recommend for the FTG if testing 6–10 ft (1.8–3 m) depths.